Contact: Cheng Huijiang
Cheng Huijiang: 13806256210
Address: Wujiang District, Suzhou City,
Jiangsu Province, Fenghai town Jin Jinba Road, 333
Viscoelastic anticorrosive tape has a very good cold flow, is specifically for the buried in the pipeline on the flange and valves and other parts designed specifically for the new anti-corrosion products in the buried pipeline corrosion works in a very important Status, and viscoelastic anti-corrosion tape construction process has a certain standard, in the following will be a simple summary for everyone.
The company is well-known viscoelastic anti-corrosion tape vendors, product quality is good, the price is reasonable, by the customer's trust and praise. Viscoelastic anti-corrosion tape is specially designed for buried pipes and other anti-corrosion products such as flanges, valves, pumps and other anti-corrosion products designed in the anti-corrosion engineering has been widely used.
1. Surface treatment requirements as low as ST2 / 3, without borax rust; construction conditions are limited, can also be used manual or power tools rust to St 3. After the steel surface is qualified, it must be painted as soon as possible before rust. Concrete surface should be dry (surface water less than 6%), remove the surface of loose material, showing a solid surface.
2. Formulate glue, a variety of stereotypes glue composition is different, can not mix.
3. Weld putty: putty by a good stereotypes with about twice the weight of the talcum powder and mix thoroughly made, should be tuned with the use of good after finishing within 2h.
4. Gluing and wrapping: the surface of the steel before the coating must be dry, the amount of coating required, not leakage coating, immediately after the baseband wrapped, wrapped around the tape must be tight, so close contact with the surface without drum package Immediately after the belt on the belt and then even brush a layer of stereotypes glue.
5. Leakage and trapping: anti-corrosion layer wrapped around after standing dry, at least 8h to keep no rain, do not soak. To be anti-coating work hard, with EDM leak detector to check due to uneven coating or leakage of the formation of a small amount of pinholes, and the emergence of pinhole with chalk circle mark and as soon as possible coated plastic seal leakage.
6. Quality inspection: According to the conditions and methods specified in the anti-corrosion engineering standards, the appearance, thickness, EDM and adhesion inspection, and defect repair to qualified.
The above is today for everyone to introduce the viscoelastic anti-corrosion tape construction process, we hope that the correct use of this product, so as to ensure the quality of the late construction, if you have other related issues, you can contact our customer service for consultation. Viscoelastic anti-corrosion glue