一分彩

新闻

NEWS CENTER

NEWS CENTER

CONTACT US

Contact: Cheng Huiqiang

Cheng Huiqiang:13806256210

Telephone:0512-63982510


Contact:Li Cong

Mobile phone:13962536717

Fax:0512-63982520

Address:No. 333, Jinxian Road, Jinjiaba, FENHU Town, Wujiang District, Suzhou City, Jiangsu Province

Website:www.diendanthanhly.net

Introduction of several construction methods of anticorrosive adhesive tape

Your current location: Home >> News >> Company news

Introduction of several construction methods of anticorrosive adhesive tape

Release date:2017-08-25 Author: Click:

Anticorrosive tape Introduction of several construction methods


Anticorrosive adhesive tape is a product with very good effect. Therefore, it has been widely used. There are many ways to construct this product, and different construction methods are suitable for different projects. Below, Jining Xun Da pipeline anticorrosion material company introduces several construction methods for this product.

1. Anticorrosive tape for adhesive tape prefabrication line

The steel pipe is mounted on a driving wheel which has several pairs of tubes with a certain angle, and the steel pipe edges rotate and move along. Along the pipeline, steel wheel is used for rust removal or blasting, rust removal, priming and tape winding device. The steel pipe will complete the whole belt winding anticorrosion construction after the operation line.

This method is of high automation and good construction quality, and is suitable for large-scale engineering and steel pipe anticorrosion engineering with various diameters.

Two, adhesive tape manual winding method

Put the steel pipe in good shape and remove rust with wire brush. Then primer is painted by hand. When the primer is dry, after touching the hands, the tape will be rolled up by hand, tightened and transferred manually according to the lap requirements.

This method is suitable for small batch and anticorrosive construction with various diameters.

Several construction methods of anticorrosive adhesive tape

Three, adhesive tape manual machine winding method.

Remove the rust on the steel pipe or the pipe line, remove the rust with the manual wire brush, and coat the primer. The manual winding machine is clamped on the steel pipe, after adjusting the rubber wheel to a suitable angle, the adhesive tape is placed on the reel shaft, and the wound winding machine is wound by hand.

This method is suitable for on-site construction, especially for repair and repair of non-stop corrosion protection layer of existing pipelines.

Four. Winding method of power machine.

The steel pipe is placed on the rubber wheel driven by the motor through the decelerating device to load the steel tube, and the motor driven by the driving device is driven to rotate the steel pipe uniformly. Use artificial wire brush to remove rust, roll brush primer, then put the tape on the reel or hand-held reel of the trolley, and move slowly along the lap request. This method is suitable for workshop prefabrication or large batch steel pipe anticorrosion engineering.

The above is the construction method of anticorrosive tape. If you want to know more, you can visit our website to browse more contents. Polyethylene anticorrosive adhesive tape manufacturer


Recently viewed:

Suzhou Qiangjiang Pipeline Anticorrosive Material Co., Ltd.

Contact: Cheng Huiqiang

Contact : Li Cong
Telephone:0512-63982510 Mobile phone:13962536717

Mobile phone:13806256210

Fax:0512-63982520
Address: No. 333, Jinxian Road, Jinjiaba, Wujiang District, Suzhou, Jiangsu
Website:www.diendanthanhly.net

Scan